- professionally designed intelligent program-controlled device for all airsoft electric guns (AEG) with 500mm long wires on each side
- four high quality 1,5qmm (AWG16) power wires covered with silicon insulation and two 0,25qmm (AWG24) signal wires
- designed for spring M130 without restriction and maximum spring m150 with longer delay between shots and ROF 20bb/s. For higher load use extreme variant of this device
- device size 39x19x13mm
- easy to understand 6 wires connection
- processor unit current consumption is only 4.5 mA
- coated with lacquer, which protects device against water
- in package is installation manual in English, which is in bookmark "MEDIA" online

Processor unit benefits:
- mosfet with active breaking of motor
- in weapons with very high rate of fire (ROF) Active break solves multiple shots in semi mode
- in semi fire mode piston isn't partially stretched, spring is fully released, parts in mechabox aren't under strain and nozzle locks hop-up chamber in greater part (depends on ROF). The braking effect is the most powerful with high torgue motor
- in auto fire mode piston stops in random position due the mechabox design. But this stopping is much faster with Active break
- monitoring current, voltage and temperature of Processor unit components
- fire modes, burst, motor speed, time delay and overdischarge Li-xx battery protection are programmable through trigger gun
- motor vibrates as feedback indication for user

Fire mode:
Save - Semi – Full
Save - Semi - Burst/Full
Save - Semi - Semi
Save - Semi - Burst
Save - Semi - Semi (delay)
Save - Burst - Full

Advanced configuration:
- BURST TIME - Reduction
- BURST TIME - Increase
- MOTOR SPEED - Reduction
- MOTOR SPEED - Increase
- DELAY->1 pull: Short (MODE 2)
                  2 pull: Normal (MODE 2)
                  3 pull: Long (MODE 2)
                  4 pull: Short (MODE 5)
                  5 pull: Normal (MODE 5)
                  6 pull: Long (MODE 5)
- ACTIVE BREAKING->1 pull: ON
                                         2 pull: OFF
- SMART RATE OF FIRE->1 pull: ON
                                               2 pull: OFF
- LI-XX BATTERY CUT OFF->1 pull: OFF
                                                    2 pull: 2S li-pol
                                                    3 pull: 3S li-pol
                                                    4 pull: 3S li-fe
                                                    5 pull: 3S li-on
- FACTORY RESET

WARNING: Installation of this device leave to expert, who could solder and disassemble airsoft gun. Never user soldering gun!